YITIAN NEWS



22

2022

-

06

Maintenance Tips for Bathroom Faucet Sets from China manufacturer

Author:


The bathroom faucet set from China manufacturer is an indispensable item in our daily life. Although it is small and usable, we should pay attention to maintenance in daily use, so that it will not affect its service life.
Maintenance Tips for Bathroom Faucet Sets from China manufacturer:
1. Please install it by experienced and qualified professionals. When installing the bathroom faucet set from China manufacturer, the faucet should try not to collide with hard objects, and do not leave cement, glue, etc. on the surface, so as not to damage the gloss of the surface coating. If your faucet is used in a newly built house, because the water supply pipe network is newly laid, there will definitely be sand and other impurities in the water. Before installation, pay attention to remove the debris in the pipe, and drain the water for a long time until the water quality becomes clear before installation.
2. When using the bathroom faucet set from China manufacturer, do not use excessive force to cause man-made damage, just turn it gently.

bathroom faucet set from China manufacturer
3. After normal use, the surface of the bathroom faucet set from China manufacturer should be wiped clean. Do not support or use the faucet handle as an armrest.
4. Under the condition that the water pressure is not lower than 0.02mpa, after using for a period of time, if you find that the water output decreases, or even the water heater turns off, cut off the flow of cold and hot water, and use a wrench to gently unscrew the water nozzle at the water outlet of the faucet. The screen cover, after cleaning the impurities, is carefully installed, and it can generally be restored to its original state.
5. The shower head metal hose of the bathroom faucet set from China manufacturer should be kept in a natural stretch, and do not coil it around the faucet when not in use. At the same time, when in use or not, be careful not to form a dead angle at the joint between the hose and the valve body, so as not to break or damage the hose.